Made of a pliable, polyester, waxy resin material that will conform to any shape surface while maintaining a uniform thickness throughout. Self-Adhesive Sheets can be applied over itself to produce even thicker build-ups if necessary. The application process takes less than 5-minutes using only your hands and a utility knife to trim any overlap material.

Gamma Build Up Sheets can be used to build up grips on tennis, racquetball, squash and badminton racquets.

Application Instructions:

• Step One: Remove existing overgrip from racquet.
• Step Two: Clean handle with an alcohol based solvent and wipe with a dry cloth.
• Step Three: Trim the Add-on grip to size.
• Step Four: Remove paper backing from Add-On sheet to expose adhesive. Press and smooth-out the adhesive side against the full length of the first flat of the handle. Continue to press-apply sheet along each flat until starting edge is overlapped.
• Step Five: Trim and remove any overlapping build-up material with a utility knife and smooth out the seam with your thumb.
• Step Six: Apply your overgrip of choice.

Important Note: The use of a heat gun to apply this product is NOT REQUIRED and should not be used.